Table of Contents
Advertisement
4.2
Control Interface Signals
Host
computer
(1)
Send data (T/D)
This signal is the response and acknowledge for the command sent on the R/D line.
(2)
Received data (R/D)
This line sends the command and acknowledge for a response.
(3)
Send request (RTS)
This line sends a request to send a response and acknowledge for the command.
(4)
Transmission enabled (CTS)
This line sends an acceptance of RTS signal.
(5)
Terminal ready (DTR)
This signal indicates that the scanner is ready for transmission and reception. This
signal is set to off when the scanner is turned off, when the scanner is initially
checked after power>on, or when a fault is detected.
(6)
Controller ready (DSR)
This signal indicates that the host computer is ready for transmission and
reception.
4 $ 2
T/D
R/D
RTS
CTS
DTR
DSR
Figure 4.1 Control interface signal lines
50FH5037E>02
Scanner
Advertisement
Table of Contents
