Quality Of Scanned Text Or Lines Is Unsatisfactory - Fujitsu SP-1130Ne Operator's Manual

Quality of Scanned Text or Lines Is Unsatisfactory

Check the following points
● Are the glass and rollers inside the ADF clean? (page 103)
● Is the resolution appropriate? (page 103)
● Did you configure the settings in the scanner driver to scan in grayscale or color mode? (page 103)
Is there any foreign matter (such as dust or paper dust) on the document? (page 103)
●
If the problem still persists, check each item in
114) first, then contact the distributor/dealer where you purchased this product. Refer to the contact
information in the Contact List if supplied with this product, or refer to the contact information in the
Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
●
Are the glass and rollers inside the ADF clean?
Solution
Clean the dirty parts.
For details, refer to
●
Is the resolution appropriate?
Solution
Specify a higher resolution in the scanner driver.
●
Did you configure the settings in the scanner driver to scan in grayscale or color mode?
Solution
Configure the settings in the scanner driver to scan in black & white mode.
When you scan in grayscale or in color mode, the scanned image may not become sharp and clear.
●
Is there any foreign matter (such as dust or paper dust) on the document?
Solution
Remove any foreign matter off the document.
Foreign matter may get on the glass that is inside the ADF, and cause the image to appear dirty.
Daily Care (page 64).
103
Before You Contact the Scanner Service Provider (page
Troubleshooting