Removing The Network Connector - Dell Latitude Z Specifications

Back to Contents Page
Network Connector
Dell™ Latitude™ Z600 Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Network Connector

NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your
2. Remove the battery from the computer.
3. Remove the hinge covers from the computer.
4. Remove the access panel from the computer.
5. Remove the screw that secures the connector to the computer hinge.
6. Remove the network connector cover from the hinge.
7. Disconnect the network connector cable from the system board.
8. Remove the network connector from the computer.
Replacing the Network Connector
To replace the network connector, perform the above steps in reverse order.
Back to Contents Page
Computer.