NETGEAR WNDAP330 - ProSafe - Wireless Access Point Manual page 10

Access Point 1
➋
Repeat this procedure in each of the other profiles, assigning the MAC Addresses of Access
Point 3, 4 and 5 respectively to each of the profiles. Note that the Network Authentication should
be configured identically in each and all of the Access Points.
On Access Point 2, select the profile you enabled and click on the Edit button at the bottom of the
screen to change the details of the profile:
Access Point 2, 3, 4 and 5
Repeat this same step in each of the other Access Points. They will all be configured in the exact
same way: Same Network Authentication settings and the MAC address of Access Point 1 in the
Remote MAC Address field.
• Enter the MAC Adress of Access
Point 2 (
Address field.
• Enter your Network Authentication
details. Make sure the settings you
use here are set identically in both
Access Points.
Enter the MAC Adress of Access Point 1
•
( )
❶
❶
Enter your Network Authentication
•
details. Make sure the settings you use
here are set identically in both Access
Points.
) in the Remote MAC
➋
in the Remote MAC Address field.