KV-S2025C Series / KV-SU225C Series / KV-S2045C Series / KV-SU245C Series
9.3.
Operation
This section describes each operation (or status indication), according to the function item list shown in Sec. 9.2.
9.3.1.
Scanner Status
This function indicates scanner status, updating it every few seconds. The status messages and its contents are as follows.
Classified Code
—
U10
U11, U12, U13, U16
U18
U23
U30
Fxx
—
—
—
Fig. 9.3.1 Scanner Status
9.3.2.
Error Code
Classified and Error codes are as follows. And troubleshooting for this error message and codes is shown in Sec. 10.2.
Table 9.3.2 Classified Code Outline
Table 9.3.3 Error Code Outline
Status Message
Scanner has no error.
No Paper!
Please set the paper.
Jam occurred!
Please open the door and remove the paper.
Document remains in scanner!
Please open the door and remove the paper.
Double Feed occurred!
Please open the door and remove the paper.
Scanner Door is open!
Please close the door.
System error occurred!
Please consult with a service representative.
*** Warning ***
The rollers need to be cleaned.
Please clean the rollers.
*** Warning ***
The rollers need to be replaced.
Please replace the rollers.
Scanner is not connected!
Contents
U1-
Document
U2-
Document
U3-
Door
U4-
U5-
U6-
U7-
U8-
U9-
ST1
0×
1×
2×
3×
4×
5×
6×
7×
8×
9×
A×
B×
C×
D×
E×
F×
No error
No paper error
U11: Paper Feed Jam, U12: Jam1(around conveyor)
U13: Jam 2 (around conveyor), U16: Jam (around exit roller)
Document remains in scanner, or dust is attached around a
sensor.
Double feed error.
Door is open.
Service level error occurred.
Warning for cleaning rollers.
Warning for replacing rollers.
Scanner is not connected to PC properly.
Contents
H1-
H2-
H3-
H4-
H5-
H6-
H7-
H8-
H9-
Error contents
Communication error
Paper jam error
Door open error
Mechanical function error
Paper sensor error
Scanning error
—
—
Hardware error
Hardware error
—
—
—
—
—
—
62
Contents
Contents
F1-
F2-
Hardware
F3-
F4-
F5-
Sensor
F6-
Scanning
F7-
F8-
F9-