Configuring The Ip Address - D-Link DXS-3600-EM-4QXS Hardware Installation Manual

DXS-3600-32S>enable
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#username NewUser password 12345
DXS-3600-32S(config)#username NewUser privilege 15
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#login local
DXS-3600-32S(config-line)#end
DXS-3600-32S#
1 At the CLI command prompt, enter the command 'enable' to enter the Privileged EXEC Mode. Press Enter.
2 Enter the command 'configure terminal' to enter the Global Configuration Mode. Press Enter.
3 Enter the command 'username NewUser password 12345'. Press Enter. This will create a user account with the
username of 'NewUser' and a password of '12345'.
4 Enter the command 'username NewUser privilege 15'. Press Enter. This will configure this user account to have
Administrative (15) privileges.
5 Enter the command 'line console' to enter the Line Configuration Mode. Press Enter.
6 Enter the command 'login local'. Press Enter. This specifies that the local line requires login credentials.
7 Enter the command 'end' to exit back to the Privileged EXEC Mode.
NOTE: Passwords are case sensitive. Usernames and passwords can be up to 15 characters in
length.

Configuring the IP Address

Each switch must be assigned its own IP Address, which is used for communication with an SNMP network manager
or other TCP/IP applications. The switch's default IP address is 0.0.0.0 and should thus be configured prior to
installation. You can change the switch's default IP address to fit into your networking address range.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be
found by entering the command "show system-info" into the command line interface in the Privileged EXEC mode,
as shown below.
DXS-3600-32S>enable
DXS-3600-32S#show system-info
Device Type
MAC Address
IP Address
VLAN Name
Subnet Mask
Default Gateway
Boot PROM Version
Firmware Version
Hardware Version
Firmware Type
Serial Number
System Name
System Location
System Uptime
System Contact
DXS-3600-32S#
DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide
Figure 4-5 To create a user account
: DXS-3600 TenGigabit Ethernet Switch
: 00-01-02-03-04-00
: 0.0.0.0 (Manual)
: default
: 0.0.0.0
: 0.0.0.0
: Build 1.00.007
: Build 1.00.024
:
: EI
: D1234567890
:
:
: 0 days, 0 hours, 20 minutes, 59 seconds
:
Figure 4-6 The 'show system-info' command
19