Installing Fan Modules Into The Fan Module Ports - D-Link DXS-3600-EM-4QXS Hardware Installation Manual

• Use a minimum of 18 AWG stranded copper wire for grounding. The wire should be long enough to reach from the
installed switch to the facility ground point.
• Torque screwdriver with a 1/4-inch flat blade.
• Ground additional hardware appropriately to the earth ground connection at your site.

Installing Fan Modules into the Fan Module Ports

Located on the rear panel of this switch there are three fan module ports.
The user can easily remove and insert fan modules into these ports.
NOTE: All fan modules, installed in this switch, should support the same air-flow direction to prevent
thermal issues.
DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide
Figure 2-9 Installing a Fan Module
13