Dynamic (Cable) - D-Link DIR-850L User Manual

Section 3 - Configuration
My Internet Select Dynamic IP (DHCP) to obtain IP Address information
Connection: automatically from your ISP. Select this option if your ISP does not
give you any IP numbers to use. This option is commonly used for
cable modem services.
Host Name:
The Host Name is optional but may be required by some ISPs. Leave
blank if you are not sure.
Use Unicasting:
Check the box if you are having problems obtaining an IP address
from your ISP.
Primary/Secondary
Enter the Primary and secondary DNS server IP addresses assigned
DNS Server:
by your ISP. These addresses are usually obtained automatically
from your ISP. Leave blank if you did not specifically receive these
from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU
for optimal performance with your specific ISP. 1500 is the default MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Clone Your PC's MAC Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-850L User Manual
Internet Setup

Dynamic (Cable)

29