Establishing A Wireless Connection And Playing Back - Yamaha RX-A1010 Owner's Manual

SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI USB USB NET NET
DOCK DOCK
DOCK TUNER TUNER [ A ] [ A ] [ B ] [ B ]
SCENE
1 2 3 4
PROGRAM MUTE VOLUME
TOP MENU POP-UP/MENU
OPTION OPTION
ON SCREEN OPTION
Cursor keys
ENTER
ENTER ENTER
RETURN DISPLAY
MODE
LIVE
CLASSICAL ENTERTAIN
CLUB
PRESET
MOVIE STEREO STRAIGHT
TV
PURE
INPUT
DIRECT
TV VOL TV CH
MUTE
4
Select the Bluetooth receiver from the device list
and enter the pass key "0000".
"Completed" appears when the pairing is complete.
DOCK DOCK
TAG
HD
PRE AMP PARTY
ZONE ZONE ZONE
Completed
IN OUT 1 OUT 2 2 3 4
SLEEP
3
HD
• Depending on Bluetooth components, "BT connected" appears when the
pairing is complete. In this case, the wireless connection has been already
established. You just need to start playback on your Bluetooth component to
enjoy it on this unit.
5
To exit from the menu, press OPTION.
Establishing a wireless connection and
playing back
When the pairing is complete, follow the procedure below to
establish a wireless connection between your Bluetooth component
MUTE VOLUME and the Bluetooth receiver. When the connection is established,
ADAPTIVE DRC
PL L C R PR
SL SW1 SW SW2 SR
this unit outputs sounds played back on the Bluetooth component.
PL SBL SB SBR PR
• Depending on Bluetooth components, a wireless connection is established
automatically or by operating the Bluetooth component. In this case, you can skip
steps 2 and 3 below.
• Texts in parentheses denote indications on the front display.
1
Press DOCK to select "DOCK" as the input source.
2
Press OPTION.
3
Use the cursor keys to select "Connect" (Connect)
and then press ENTER.
"BT connected" appears when the wireless connection is
established.
DOCK
TAG
HD
IN OUT 1
• If the Bluetooth receiver is paired with more than one Bluetooth component,
• "Not found" appears if a connection cannot be established. Check the
4
Start playback on your Bluetooth component.
• To terminate the wireless connection, select "Disconnect" (Disconnect) in
BT connected
MUTE
PRE AMP PARTY
ZONE ZONE ZONE ADAPTIVE
2 3 4
OUT 2
SLEEP
HD 3
the lastly-connected component is automatically chosen. When you cannot
establish a connection with an intended component, perform pairing again
or perform the connection operation from the intended component.
followings and try again.
- The Bluetooth component and Bluetooth receiver are paired.
- The Bluetooth component is turned on and the Bluetooth mode is enabled.
- The Bluetooth component is within 10 m (32 ft) of the Bluetooth receiver.
step 3.
VOLUME
DRC
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
71
En