Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Speaker Imp.); Turning On/Off The Remote Control Sensor (Remote Sensor); Selecting The Remote Control Id (Remote Con Amp) - Yamaha RX-A1010 Owner's Manual

ADVANCED SETUP menu items

Item Function
SPEAKER IMP. Changes the speaker impedance setting.
Turns on/off of the remote control sensor on the main
REMOTE SENSOR
unit.
REMOTE CON AMP Selects the remote control ID of the main unit.
(Asia and General models only)
TUNER FRQ STEP
Changes the frequency step setting.
TV FORMAT Switches the video signal type.
MONITOR CHECK Removes the limitation on HDMI video output.
Creates backup of the settings of this unit, or recovers
RECOV./BACKUP
the settings from the backup.
INITIALIZE Restores the default settings.
FIRM UPDATE Updates the firmware.
Checks the version of firmware currently installed on
VERSION
this unit.

Changing the speaker impedance setting (SPEAKER IMP.)

SP IMP. - SPEAKER IMP.
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
8 MIN
2 3 4
IN OUT 1 OUT 2
ENHANCER SLEEP
HD 3
Change the speaker impedance settings of unit depending on the impedance of the
speakers connected.
Settings
Select this when you connect 6-ohm speakers to this unit. You can also
6 Ω MIN
use 4-ohm speakers as the front speakers.
8 Ω MIN (default)
Select this when you connect 8-ohm or higher speakers to this unit.
MUTE VOLUME
ADAPTIVE DRC
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
Turning on/off the remote control sensor
(REMOTE SENSOR)
Page
120
SP IMP. - REMOTE SENSOR
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
2 3 4
IN OUT 1 OUT 2
120
ENHANCER SLEEP
3
HD
120 Turn on/off the remote control sensor on the main unit. While the remote control sensor
is turned off, you cannot control this unit from the remote control.
121
Settings
121
ON (default)
121
OFF
122

Selecting the remote control ID (REMOTE CON AMP)

122
122
SP IMP. - REMOTE CON AMP
DOCK
122
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
2 3 4
IN OUT 1 OUT 2
ENHANCER SLEEP
3
HD
Select the remote control ID of the main unit so that it matches to the ID of the remote
control (default: ID1). When using multiple Yamaha AV receivers, you can set each
remote control with a unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■
Changing the remote control ID of the remote control
Perform each of the following steps within 30 seconds. Otherwise, the setting will be
automatically canceled.
1
Press SETUP.
2
Use the cursor keys ( / ) to select "PRESET" and press ENTER.
PRESET
3
Press RECEIVER
4
Use the numeric keys or cursor keys to enter "5019" (ID1) or "5020" (ID2).
5020
MUTE VOLUME
ADAPTIVE DRC
ON
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
Turns on the remote control sensor.
Turns off the remote control sensor.
MUTE VOLUME
ADAPTIVE DRC
ID1
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
and press ENTER.
120
En