Showing And Removing Created Users; Setting Snmp Read/Write Access - Dell Force10 S2410-01-10GE-24P Configuration Manual

Figure 3-9. Creating a User and a Password
Force10 (Config)#username w_turner passwd willspwd
User login name and password are set.
Force10 (Config)#no username w_turner
Force10 (Config)#username w_turner passwd newpwd
User login name and password are set.Password Changed!
Note: SFTOS 2.5.1.3 adds support for the following special characters: , . { } | , in other words,
period, comma, open bracket, close bracket, and bar.

Showing and Removing Created Users

An alternative to the
no username
created users. The following example shows the
Figure 3-10. Showing Created Users
Force10 #show users
SNMPv3
User Name User Access Mode
---------- ----------------
admin Read/Write
w_turner Read/Write
Force10 #clear pass
Are you sure you want to reset all passwords? (y/n)y
Passwords Reset!

Setting SNMP Read/Write Access

The command users snmpv3 accessmode
privileges for specific users. As used above
users command displays the read and write privileges for each defined user:
Force10 (Config)#users snmpv3 accessmode student2 readwrite
Force10 #show users
User Name User Access Mode
---------- ----------------
admin Read/Write
student1 Read Only
student2 Read Only
command shown above is to use the
SNMPv3 SNMPv3
Access Mode Authentication
----------- --------------
Read/Write None
Read Only None
username
(Showing and Removing Created Users on page
SNMPv3
Access Mode Authentication
----------- --------------
Read/Write None
Read Only None
Read/Write None
clear pass
show users command and the
Encryption
----------
None
None
{ readonly | readwrite
SNMPv3 SNMPv3
Encryption
----------
None
None
None
command to delete all
clear pass command:
} enables you to set SNMP
37), the
Getting Started | 37
show