7.
By referring to "Removing CPU/IO Module" on page 8-11, remove the CPU/IO module 0
from the server.
8.
Restore the previous CMOS clear jumper switch settings. Remove the jumper from J22
pins 9-10 and install them it on the jumper J57 pins 2-3.
9.
By referring to "Installing CPU/IO Module" on page 8-14, install the CPU/IO module 0
on the server.
10.
Reconnect only the power cord of the CPU/IO module 0 and press the POWER switch to
power on.
11.
After the startup, press the F2 key during POST to start BIOS SETUP.
12.
Make settings in SETUP as you desire and then save the settings by selecting "Exit"→
"Exit Saving Changes." Switch the power off and disconnect the power cord from the
outlet.
13.
Clear CMOS for the CPU/IO module 1 by repeating steps 3 to 12.
14.
By referring to "Installing CPU/IO Module" on page 8-14, connect both CPU/IO modules
to the device.
15.
Connect both power cords.
System Configuration 4-45