Installing Windows - NEC Express5800/320Fd-LR User Manual

Installing Windows

Windows Server 2003 x64 Editions Installation
Follow the procedure below to install.
Power on the system.
1.
Load the backup CD-ROM DISK 1 or the Windows Server 2003 x64 Edition DISK 1 into
2.
the optical disk drive.
After loading the backup CD-ROM DISC 1 or the Windows Server 2003 R2 x64 Edition
3.
DISC 1 into the optical disc drive, reset (Press <Ctrl> + <Alt> +<Del>), or power off to
reboot the NEC Express5800 series.
System launches from the CD-ROM, and NEC
EXPRESSBUILDER starts.
IMPORTANT:
When a bootable OS is already installed on the HDD, press <Enter> key while [Press any
key to boot from CD...] is appearing on the top of the screen. You do not need to operate
this if no bootable OS is installed.
If the Windows Setup screen does not appear after this operation, it means <Enter> key was
not pressed properly. Power on to restart the system and start from the beginning.
Press <F6> key while either of the following messages appears on the screen.
4.
On the top of the screen: [Setup is inspecting your computer's configuration...]
On the bottom of the screen: [Press F6 if you need to install a third party SCSI or
RAID driver]
TIPS: After pressing <F6> key, no change appears on the screen.
Windows Setup 4-27