Removal - NEC Express5800/120Ri-2 User Manual

Removal

Remove the DIMM depending on the following procedure.
NOTES:
To remove the failed DIMM, check the error message appearing in
POST or NEC ESMPRO to identify the DIMM socket (group) in
which the failed DIMM is installed.
The server operates only when at least two DIMMs are installed.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Remove the logic cover and drive cover.
4.
Remove the PCI riser module.
5.
Remove two screws securing the support arm.
6.
Remove the support arm from the chassis.
NOTE:
Press firmly the support arm before removing the screws.
When the support arm comes up, you may lose the screws.
Upgrading Your Server 9-27