Table of Contents
Advertisement
ADVANCED SETTINGS
Technical information
This menu allows the user to check the technical information for the digital receiver. This is only
necessary when a problem occurs with the digital receiver. If a problem does occur, this informa-
tion may assist customer service personnel to diagnose the problem. There are three options:
signal strength, manufacturer data, and auto update.
Signal Strength
This option assists in determining the strength of the signal used by the digital receiver. The display
shows the selected output channel and the signal strength of that channel.
Normally, the settings in this screen do not need to be adjusted, but the information from this
screen may be required by an ONdigital customer service representative.
To view the "Signal strength" menu option, press the MENU button, then press the "7" button
"Technical information," then the "1" button "Signal strength". Press the GREEN button to enter a
different UHF channel number and then the RED button to check the signal strength.
Manufacturer data
This option displays various information about the ONdigital box, such as manufacturer name,
hardware version, and software version. The information in this screen might also be used by
ONdigital customer service personnel.
Auto Update
This option is used to update the software used by the digital receiver. Updating the software might
cause some digital receiver menus and functions to be updated or new features added, but the
general operation method will not change.
You will be advised when it is necessary to carry out an update. Messages will be displayed on the
digital receiver LED display when this is taking place. The meanings of these messages are de-
scribed below.
You might also be asked by ONdigital customer service personnel to start this update.
Front panel messages
The front panel display also shows the digital receiver status during an auto update. These mes-
sages are described below.
• Auto update: Indicates the digital receiver is searching for the updated software version and will
then update the old version.
• Update error: This message indicates that the currently installed software is the latest version.
• Retrying update: This message is displayed when the digital receiver has located the update
version but is having trouble implementing the update. In this case, the "Auto update" message
will be displayed again as the update process is continued.
• Out of order: This message is displayed when the software update was unsuccessful. If you have
any questions, call the ONdigital customer service at 0870-600-9696, or contact your local retailer.
48
<BRB1056>
Advertisement
Table of Contents
