For Vigorpro 5510Gi - Draytek VigorPro 5510 Series Quick Start Manual

1 . 1 . 2 F o r V i g o r P r
1 . 1 . 2 F o r V i g o r P r
LED
ACT (Activity)
IDP (Intrusion Detection and
Prevention)
Virus
DMZ
USB
WLAN
Monitor
CSM
ISDN
LED on Connector
10
(left LED)
WAN
100
(right LED)
LAN/Monitor 100
LAN (left LED)
1000
(right LED)
Interface Description
RST Restore the default settings.
(Factory Reset) Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
configuration.
o 5 5 1 0 G i
o 5 5 1 0 G i
Status
Blinking
Off
On
(Yellow)
On
(Yellow)
On
On
Blinking
On
Blinking
Off
On
On
Off
On
Blinking
On
Off
Blinking
On
Off
Blinking
On
Off
Blinking
On
Off
Blinking
Explanation
The router is powered on and running normally.
The router is powered off.
The anti-intrusion function is enabled.
The anti-virus function is enabled.
DMZ Host is specified in certain site.
A USB device is connected and active.
The data is transmitting.
Wireless access point is ready.
Ethernet packets are transmitting over wireless LAN.
The WLAN function is inactive.
LAN traffic monitor is active.
The profile of CSM (Content Security
Management) for IM/P2P application is active. (It
is enabled from Objects Setting >> CSM Profile).
No IM/P2P, Web Content Filter, and/or URL
Content Filter application has been activated.
The ISDN service function is active.
A successful connection on the ISDN BRI B1/B2
channel.
The port is connected with 10Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is disconnected.
The data is transmitting.
4 VigorPro 5510 Quick Start Guide