Link Thermostat To Wireless Network - Honeywell PRESTIGE THX9321 System Installation Manual

Link thermostat to the wireless network
4
(if used with an EIM or TrueZONE Wireless Adapter)
Next, link all components and RedLINK
Initial powerup configuration
When the thermostat is first activated, it will lead you through the steps
necessary to define and set up your system. The steps will change depending on
the type of system and thermostat you're installing.
Setup options for THX9321
If non-zoned system:
• Setup for thermostat only
• Setup for use with EIM
If zoned system:
• Setup for EIM wired to zone panel
• Setup for thermostat wired to zone panel
• Setup for RedLINK wireless connection to zone panel
(using THM4000 TrueZONE Wireless Adapter)
Link thermostat to EIM or TrueZONE
Use the step-by-step thermostat menus to define your system type (above).
When you reach the Wireless Setup screen, follow the steps below:
C O N N E C
C O N N E C
"Connected" status light
Green flashing: In Wireless Setup mode.
•
• Green steady: System is working normally.
Red: Wireless device(s) not communicating. Check EIM and RedLINK devices.
•
At any screen you can press HELP for more information,
or press BACK to change earlier options.
69-2490_B.indd 5
accessories to the wireless network.
™
S 2
S 2
T E D
S 1
S 1
T
MCR32941
5
THX9321/9421 Prestige
Setup options for THX9421
If non-zoned system:
• Setup for EIM connection
If zoned system:
• Setup for EIM wired to zone panel
• Setup for RedLINK wireless connection to zone panel
(using THM4000 TrueZONE Wireless Adapter)
Wireless Adapter
®
Press and release the CONNECT button at the EIM or Wireless
Adapter, and make sure the "Connected" light is flashing green.
If the "Connected" light does not flash, make sure no other
RedLINK devices are in Wireless Setup mode, then try again.
If the "Connected" light does not flash on the Wireless
Adapter, consult the TrueZONE manual for help.
While the EIM light is flashing, press NEXT to link
the thermostat with the EIM. After a brief delay,
the screen will display "Device Connected."
IAQ and RF EIM
®
69-2490—03
7/13/2011 1:41:50 PM