MY16-C
Double-click the block to display the component editor for it.
Section
Parameter
1
Setting Priority
Setting Priority
2
High Sampling
Input Format
Mode
Double FS
Output Format
3
Bundle Number Input
Output
4
Serial Channel
Rx
Tx
5
Properties
Bit Length
6
Latency
NOTE
The parameters will not link immediately when Setting Priority is switched.
Please edit another parameter after switching Setting Priority.
MY16-C component editor
1
2
3
4
5
6
Setting Range
Hardware/
Software
Double Channel
Single
ON/OFF
Double Channel
Single
0 to 65279
0 to 65279
OFF, 1 - 16
OFF, 1 - 16
Bit Off
16 bit
20 bit
24 bit
5.33 ms
2.67 ms
1.33 ms
Chapter 6 Component Guide
Function
The MY16-C switch settings take priority when
"Hardware" is selected, and the DME Designer
settings take priority when "Software" is
selected.
Selects the format for 88.2/96 kHz sampling
rates.
Linked to Output Format.
When turned ON the speed of the MY card word
clock output is doubled. Only available when
the card is set as the word clock master.
Selects the format for 88.2/96 kHz sampling
rates.
Linked to Input Format.
Sets the input bundle number.
Sets the output bundle number.
Sets the serial channel for the receive side.
Sets the serial channel for the send side.
Sets the bit rate for output. Mutes the signal if
[Bit Off] is set.
Sets the delay.
DME Designer Owner's Manual
457