The number of output channels varies according to the component variation.
2 Way
Low/High
3 Way
Low/Mid/High
4 Way
Low/Low-Mid/High-Mid/High
5 Way
Sub-Low/Low/Low-Mid/High-Mid/High
6 Way
Sub-Low/Low/Low-Mid/Mid/High-Mid/High
Set the attenuation curve for the lowest band and the middle bands with the Low Pass Filter (LPF) and
High Pass Filter (HPF), and the highest band with HPF. Each frequency band has its own color, with
Low being red, Mid being green, and so on. These correspond to the colors of the lines on the graph.
Graphic Control Points
The graph control points show [Output Level] and [Frequency]. As you modify the parameters
using the knobs and edit boxes, the control points move. Also, as you drag the points, the [Output
Level] and [Frequency] parameters reflect the changes you make.
You can adjust the [Output Level] parameter by vertically dragging the control point in the center of
each curve.
You can adjust the [Frequency] parameter by horizontally dragging the control point at the
intersection of the curves for each frequency band.
Changing the [Output Level] Parameter
Chapter 6 Component Guide
DME Designer Owner's Manual
353