Dhw" Menu; Night-Time Hot-Water Temperature; Legionella Protection Day - Honeywell SDC Operating Instructions Manual

Operation
4.2.4.1
Factory setting
Setting range
NOTE
4.2.4.2
Factory setting
Setting range
Set values
56
If a reset is carried out, the RESET OK confirmation appears
briefly. Verification is then started with a call-up of the first
parameter in the respective menu once again.
After the parameter values are reset, a return to the first
parameter in the "System Parameter" menu occurs.
Pos: 52 /156-Honeywell/Bedienung/Menue_Warmwasser @ 1\m od_1207647138228_6.doc @ 9930
4.2.4

"DHW" menu

This menu contains all parameters required to program the hot-
water circuit, except the hot-water switching time programs.
Pos: 53 /156-Honeywell/Bedienung/Warm wassert-Nachttemperatur @ 1\m od_1207647183619_6.doc @ 9945

Night-time hot-water temperature

This parameter specifies the temperature in the hot-water
generator between the operational-readiness times in automatic
mode.
40 °C
5 °C to set normal hot-water temperature value
If a hot-water thermostat (see parameter 05 = transducer for hot-
water circuit) is used to detect the hot-water temperature, this
parameter is skipped.
Pos: 54 /156-Honeywell/Bedienung/Legionellenschutz_Tag @ 1\mod_1207647218838_6.doc @ 9960

Legionella protection day

OFF
OFF, MO to SU, ALL
OFF
MO to SU
ALL
The legionella protection function is not active.
Legionella protection is activated on the selected
day of the week at the legionella protection time set
in the following parameter.
The legionella protection function is activated daily
at the legionella protection time set in the next
parameter.
SDC / DHC
EN2H-0220GE51 R0308