Leds - Cisco Catalyst 3120 Hardware Installation Manual

Chapter 1 Product Overview

LEDs

You can use the switch LEDs to monitor switch module activity and performance. Graphical
representations of the LEDs described in these sections are visible in the device manager.
•
•
•
•
•
•
The System LED (SYST), stack LED (STCK), Stack Master LED (MSTR), and Stack Member LED
Note
(MMBR) are shown as item 4 in
System LED
The System LED (SYST) shows whether the system is receiving power and is functioning properly.
Table 1-2
Table 1-2
Color
Off
Blinking green
Solid green
Amber
Stack LED
To see the status of the StackWise Plus ports, press the Mode button. The Stack LED (STCK) is green
when the StackWise Plus ports are up and amber when the ports are down. The bottom two 10-Gigabit
Ethernet module slot LEDs show the status for StackWise Plus ports 1 and 2, respectively (see item 11
in Figure 1-1 on page
When in stack mode, if both 10-Gigabit Ethernet uplink port LEDs are green, the stack is operating at
full bandwidth. If one or both of the 10-Gigabit uplink LEDs are not green, the stack is not operating at
full bandwidth.
See the
OL-12246-01
System LED, page 1-5
Stack LED, page 1-5
Stack Master LED, page 1-6
Stack Member LED, page 1-6
UID and Health LEDs, page 1-6
RJ-45 Uplink Port LEDs, page 1-6
lists the LED colors and their meanings.
System LED
System Status
System is not powered on.
POST is in progress.
System is operating normally.
System is receiving power but is not functioning properly.
1-2).
"LED Behavior in Stack Mode" section on page 1-8
Figure 1-1 on page 1-2.
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
for more information.
Other Features
1-5