Pioneer RM-V2550 Manual page 136

ADJUSTMENTS
[4]<GWB> (GET W/B DATA) — White balance adjustment data is output.
Format : Output in the following order.
1 STX (02H)
2 <LWT>/ LINEAR WHITE
3 <CNT>/CONTRAST
4 <BRT>/BRIGHTNESS
5 <COL>/COLOR
6 <TNT>/TINT
7 <BLW>/BLUE LOW-LIGHT
8 <GLW>/GREEN LOW-LIGHT
9 <RLW>/RED LOW-LIGHT
0 <BHI>/BLUE HIGH-LIGHT
- <GHI>/GREEN HIGH-LIGHT
= <RHI>/RED HIGH-LIGHT
~ <SHP>/SHARPNESS
! <ABL>/ABL LEVEL
@ <ABG>/ABL GAIN
# ETX (03H)
(Note 1) Dummy when INPUT=RGB
(Note 2) No dependent on mode. (Has one data.)
(Note 3) Dummy when PAL signal is input. (INPUT=VIDEO or Y/C)
(Note 4) Dummy when COMBINATION=OFF (Data is output when COMBINATION=ON)
(Note 5) SHARPNESS data for OFF is output when MULTI=OFF, and SHARPNESS data for ON is output when
MULTI=ON.
[5] GVO (GET ABL VOLTAGE) — The ABL voltage is converted within the range of 0 to 5V, identified in 256 steps
and output.
[6] <GUS> (GET CONV. USER DATA) — Deflection and convergence data memory area setting state is output.
1 STX (02H)
2 Memory area selected when INPUT=VIDEO or Y/C & input signal=NTSC.
Example)US 1:Indicates CONV.MEMO-1 is selected.
3 Memory area selected when INPUT=VIDEO or Y/C & input signal=PAL
(Or other than NTSC, containing no signals).
Example)US 2:Indicates CONV.MEMO-2 is selected.
4 Memory area selected when INPUT=RGB & input signal=NTSC.
Example)US 1:Indicates CONV.MEMO-1 is selected.
5 Memory area selected when INPUT=RGB & input signal=PAL
(Or other than NTSC, containing no signals).
Example)US 2:Indicates CONV.MEMO-2 is selected.
6 IETX (03H)
126
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE) (Note 1)
adjustment data (3 BYTE) (Note 1) and (Note 3)
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE)
adjustment data (3 BYTE) (Note 1) and (Note 5)
(3 BYTE) (Note 4)
adjustment data
adjustment data (3 BYTE) (Note 2)
(3 BYTE)
(3 BYTE)
(3 BYTE)
(3 BYTE)
(3 BYTE)