Table of Contents
Advertisement
Installing
or removing
battery
cartridge
• Always
switch off the tool before
insertion
or removal
of the battery
cartridge.
• To remove the battery cartridge, pull out
the set plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the barrel.
• To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
usingthe tool.
Set plate
Battery
cartridge
• Do not use force when inserting
the battery
cartridge.
If the cartridge
does not slide in easily,
it is not being inserted
correctly.
Charging
Plug the fast charger into your
power
source. Insert the battery
cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sidesas their
Charging I
Reset button
respective markings on the fast charger.
Insert the cartridge fully into the port so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If the charging light does not come on,
press the reset button (yellow) first, then
the start button (red). If the charging light
goes out within 10 seconds even after pressing the reset button and start button a couple
of times, the battery cartridge is dead. (CAUTION:
Wait for more than 5 seconds after
the charging light goes out to press the reset button again.) Replace it with a new one.
When the charging light goes out after about one hour, you may remove the fully charged
battery cartridge.
After charging, unplug the charger from the power source.
CAUTION:
• Your new battery
cartridge
is not charged.
You will need to charge it before
use.
• Do not
keep the button
pressed in with
tape,
etc. or the circuit
will
not function
pro-
perly.
Also,
a malfunction
of the charger
may
result
possibly
causing
overheating,
etc.
• If you
try to charge
a cartridge
from
a just-operated
tool,
sometimes
the charging
light
will
not come
on. If this occurs,
let the cartridge
cool off
for a while.
Then
re-insert
it
and try to charge
it once more.
Advertisement
Table of Contents
