RIDGID JP06101 Operator's Manual page 27

OPERATION
SETTING THE FENCE FOR A 135° BEVEL STOP
See Figure 37.
n Loosen bevel lock handle.
n Flip the 90° stop bar out of the way and move the fence
until it contacts the 135° stop.
n Make sure fence is tight against the stop and check the
angle using the included angle gauge.
n Using the angle gauge, set the fence at 135° to the outfeed
table and tighten the bevel lock handle.
n Loosen the jam nut on the 135° stop screw.
n Turn the stop screw so it touches the stop. Tighten the
jam nut.
n Loosen the bevel lock knob.
n Move the fence to any angle and then return it to the
index. Check for accuracy with the angle gauge.
FENCE LOCK
KNOB
FENCE
27
135° STOP
SCREW
BEVEL LOCK
HANDLE
ANGLE
GAUGE
Fig. 37