5.
Figure 37
Figure 37.
Make sure that the blade teeth will not
contact the guide blocks when the blade is
against the rear support bearing during the
cut.
6.
7.
8.
Note 0.004" is approximately the thickness
of a piece of paper.
9.
Whenever changing a blade or adjusting
tension and tracking, the upper and lower
blade support bearings and guide-blocks
must be properly adjusted before cutting
operations.
Calibrating Table Tilt
Scale
Tools Needed:
To calibrate the pointer on the table tilt scale:
1.
2.
38
Figure 38.
3.
4.
Qty
Figure