Sony SLV-792HF Operating Instructions Manual page 10

Step 3: Hookups (continued)
[
[] Use this hookup if your TV has the S-Link
TM
function
VCR
®®® u.E., ,.
SUNK IN
I I I I | _ AUDIO
S LINK
i
Audio/video cable (supplied)
Stereo receiver
i
! !
-r
Audio cable (not supplied)
Note
• To play a tape in stereo, you must use the A/V connection.
I
VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
L# .......... "iii i
SETSELECT ::_j_
QUiT :
Set AUTO ANT SELECT
to OFF and press OK.
TUNER AUDIO
APC
TAPE SELECT
AUTO TAPE SPEED
FAVORITE CH
SHARPNESS
_RETURN
SELECT:_
SET :
QUIT :
For details, see page 100.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
10r
Getting Started