INSTALL
HOOD
I Hang hood from (4) mounting screws. Slide hood towards
wall until mounting screws are engaged in narrow end of
(4) keyholes. Tighten mounting screws securely. A long
screwdriver works best.
4 Install (2) PAR20, 50 W Maximum Halogen Bulbs or
(2) R16, 40 W Maximum Incandescent
Bulbs. Purchase
bulbs separately.
PAR20,
50W MAX.
HALOGEN
BULB (2)
-
or-
R16,
40W MAX.
INCANDESCENT
BULB (2)
KEYHOLE (4)
MOUNTING SCREW (4)
2 Replace
bottom cover.
3 Connect
ductwork
to hood. Use duet tape to make joints
secure and air tight.
DUCT
TAPE
5 Replace filters, turn on power at service panel and test for
proper operation.
NON-DUCTED
FILTERS
If hood is to be installed Non-Ducted:
• Attach charcoal filters to the aluminum mesh filters. Be
• Purchase a set of (2) charcoal filters, model KBK-330,
sure that the sides with the blue and yellow stripes are
from your local distributor, retailer or from Sharp (see
facing down (toward the range top).
page 2).