Table of Contents
Advertisement
D
f.
_\
,, Preparation
Preparing the remote control unit
Inserting
batteries
1
Open the battery cover.
Allowed
operation
range
of the
remote
control
unit
Operate the remote control unit while pointing it toward tile
remote control sensor (_1) located at the bottom right of the
front panel of the Plasma Display, The distance from the remote
control sensor must be within 7 m (23 feet) and the angle
relative to the sensor must be within 30 degrees in the right or
left direction,
2
Insert the supplied two AA size batteries.
• The battery polarities must correspond with the (+) and
(-) indicators in the battery compartment,
3
Close the battery cover.
Cautions
regarding
batteries
• Tile remote control unit cannot operate the system if tile
batteries in the unit are empty, When this happens, replace
the batteries with new ones,
• Do not use manganese batteries, When you replace the
batteries, use alkaline ones,
• Do not mix batteries of different types, Different types of
batteries have different characteristics,
• Do not mix old and new batteries, Mixing old and new
batteries can shorlen the life of new batteries or cause
chemical leakage in old batteries,
• Do not leave dead batteries in the remote control unit;
chemical leakage will occur, If you find any chemical leakage,
wipe thoroughly with a cloth,
• The batteries supplied with this product may have a shorler
life expectancy due to storage conditions,
• If you will not use the remote control unit for an extended
period of time, remove the batteries from it,
_k
CAUTION
• WHEN DISPOSING
OF USED BATTERIES,
BE SURE
TO COMPLY WITH GOVERNMENT
REGULATIONS
AND ENVIRONMENTAL
PROTECTION
GUIDELINES
THAT APPLY IN YOUR COUNTRY
OR AREA,
Remote
control
30 °
sensor
Cautions
regarding
the
remote
control
unit
• Do not expose the remote control unit to shock, liquid, or
high humidity,
• Do not place the remote control unit under direct sunlight;
the unit may deform,
• The remote control unit may not work properly if the remote
sensor window of the Plasma Display is under direct sunlight
or strong lighting, In such case, change the angle of the
lighting or Plasma Display, or operate the remote control unit
closer to the remote sensor window,
• When any obstacle exists between the remote control unit
and the remote control sensor, the remote control unit may
not function,
• As the batteries become empty, the remote control unit can
function within a shorler distance from the remote control
sensor, Replace the batteries with new ones if necessary,
• The Plasma Display emits very weak infrared rays from its
screen, If you place such equipment operated through
infrared remote control as a VCR nearby, that equipment may
not receive commands from its remote control unit properly
or entirely, If this is the case, place that equipment at a
location far enough from the Plasma Display,
• Depending on the installation environment, infrared rays
from the Plasma Display may not allow this system to
properly receive commands from the remote control unit or
may shorten allowable distances between the remote control
unit and the remote control sensor, The strength of infrared
rays emitted from the screen differs, depending on images
displayed on the screen,
IL
pZl]
ER
Hide quick links:
Advertisement
Table of Contents
