Cable Connections For Watching Digital And/Or Conventional Tv Channels; Preparing The Remote Control Unit; Inserting Batteries - Pioneer PDP-5016HD Operating Instructions Manual

Preparation
Cable connections for watching digital
and/or conventional TV channels
This system is equipped with two terminals for inputting TV
broadcasting signals: ANTENNA IN and DTV-ANTENNA IN. The
ANTENNA IN terminal accepts conventional TV broadcasting
signals. The DTV-ANTENNA IN terminal accepts digital TV
broadcasting signals. When using a cable TV, connect to the
ANTENNA IN terminal to watch conventional TV channels, and
connect to the DTV-ANTENNA IN terminal to watch digital TV
channels (see the diagrams below).
It is recommended to use an outdoor antenna to enjoy clearer
pictures.
Connecting an antenna of digital TV
Cable TV
DTV-
ANTENNA IN
Coaxial
cable
Connecting an antenna or cable of
analog TV
Cable TV
Cable
Converter
• Be sure to connect coaxial cables as shown above. Signal reception
may fail if not properly connected.
Coaxial
cable
Coaxial cable
ANTENNA IN

Preparing the remote control unit

Inserting batteries

1
Open the battery cover.
2
Load the supplied two AAA size batteries while inserting
their respective negative polarity (–) ends first.
• The battery polarities must correspond with the (+) and
(–) indicators in the battery compartment.
3
Close the battery cover.
05
15
En