Dual Screen / Pip / Multipip - Philips 42PF9996 Owner's Manual

Press the PIP button to switch on Dual screen, PIP or one of the PIP
modes according to the format selection made in the PIP format list in
the General menu. See Settings, General, p. 8.
Press the PIP button again.The screen that has a yellow border will
become the full main screen picture.
Notes:
Continuing to hold the PIP button down will cycle the TV through the
various formats (Dual screen, PIP,PiP 3 or PiP 6), launching a new format
after each second the button is held down. After standby of the TV,the
preference as set in the Settings, General menu is used,
- It is not possible to display a HDMI or HD source in a Dual screen/PIP
screen,
When Dual screen mode is selected, two picture formats are supported: Full
screen or 4:3 letterbox picture format (vertical squeeze).
Audio from the nght screen or the PIP plays to the headphones.
Display options
Dual screen PIP PIP 3
©
PIP6
• Press the cursor right to highlight the right screen.
• Press the cursor down to highlight the single PIP screen.
• Press the cursor right to enter the Multipip screen and then use
the cursor buttons to navigate through the PIP screens and to
highlight a PIP screen.
ChangingTV channels or external sources in left, right, PIP or
Multipip screen
• Press the -CH+ buttons or the SURF button or the digit buttons in
order to change theTV channels or external sources in the
highlighted screen.
Scan PIP3 or PIP 6 0
Navigate to the lowest PIP and press the
cursor clown to display a following series of PIP 0
screens,
Define the position and the size of the single
PIP screen
Select a Dual screen mode with a single PIP
screen,
Press the cursor down to highlight the PIP
screen.A PIP menu appears with which you can
define the position and the size of the PIP
screen,
Note: When the PiP menu times out, press the OK
button to make it reappear:
_I Press the cursor down again to select Position
or Size.
Press the OK button or the cursor right to
activate,
Use the cursor buttons to define the position
of the PIP screen. Use the cursor left/right to
define the size of the PIP screen.
Press the OK button.The PIP menu reappears,
Press the cursor up to the top of the menu to
highlight the main screen again.
0 Press the OK button to switch off the menu or
wait until it is timed out,
On-Screen information
The highlighted On-Screen information,which
appears when changing channels, always refers
to the active screen,
18