Table of Contents
Advertisement
LAN1 BCM5784 Device
LAN1 Option ROM
LAN2 BCM5784 Device
LAN2 Option ROM
Configure SATA#1-6 as
AHCI CD/DVD Boot TIme out
Power Management Setup
Suspend Mode
AC Recovery
Remote Wakeup
Auto Power On
Frequency/Voltage Control
QPI Links SPeed
QPI Frequency
Memory Frequency
Uncore Ratio
CPU Core (Non-Turbo)Ratio
BIOS Security Features
Change Supervisor Password
Change User Password
Exit
Exit Options
Boot Sequence
This feature allows you to change the boot sequence for the bootable devices installed on your computer.
Option Settings
Hard Drive — The computer attempts to boot from the primary hard drive. If no operating system is on the drive, the computer attempts to boot from
l
the next bootable device in the boot sequence.
CD Drive — The computer attempts to boot from the CD drive. If no CD is in the drive, or if the CD has no operating system, the computer attempts to
l
boot from the next bootable device in the boot sequence.
USB Flash Device — The computer attempts to boot from the USB drive. If no USB is in the drive the computer attempts to boot from the next bootable
l
device in the boot sequence.
NOTE:
To boot to a USB device, the device must be bootable. To ensure that your device is bootable, check the device documentation.
NOTE:
An error message is generated only after the computer attempts to boot from every device in the boot sequence and no operating system is
found.
Allows you to enable or disable the onboard network
controller.
Allows you to enable or disable the network
controllers boot option.
Allows you to enable or disable the onboard network
controller.
Allows you to enable or disable the network
controllers boot option.
Allows you to configure the operating mode of the
integrated hard drive controller.
Allows you to set the wait time for SATA CD/DVD in
AHCI mode.
This option sets the energy-saving mode of the ACPI
function.
This option sets what action the PC takes when
power is restored.
This option sets the system to wake up from an
onboard LAN, PCIE-X1 LAN card, or a PCI LAN card.
This option allows the computer to start up at a
certain time.
Allows you to change the QuickPath Interconnect
(QPI) Links to full-speed or slow-mode.
Allows you to change the (QPI) frequency.
Allows you to force a DDR3 frequency slower than the
detected frequency.
Allows you to adjust the Uncore Ratio.
Sets the ratio between CPU Core Clock and the FSB
Frequency.
Allows you to change the supervisor password.
Allows you to change the user password. You cannot
use the user password to enter the BIOS setup,
during POST.
Provides options to Save Changes and Exit, Discard
Changes and Exit, Load Optimal Defaults, and
Discard Changes.
Advertisement
Table of Contents
