Special Features - Mitsubishi WS-48511 Guide Network Manual

Special Features
Device Selection Menu
This menu allows you to:
• Select the device for viewing on the TV.
• Select TV speakers or A/V Receiver speakers for the
audio.
• Change a NetCommand
TM
compatible A/V Receiver's
inputs automatically.
• Power NetCommand
TM
devices on or off.
• Verify NetCommandTM recordings and peer-to-peer
connections.
• Cancel recordings or peer-to-peer connections,
• Display the menu for HAVi devices,
Transport Menu
This menu allows you to operate the transport
functions of NetCommand
TM
compatible IR
controlled and IEEE 1394 recording and playback
devices.
Record and Connect Buttons
The Record button on the remote control will allow
you to begin a recording or schedule a delayed
recording using NetCommand
TM.
The CONNECT
button allows you to establish a peer-to-peer
connection between two IEEE 1394 devices
connected to the TV network.
Track List
The Track List allows you to play, select or delete
the programs stored on your AV Disc.
NetCommand
TM
Setup
For NetCommand
TM
traditional devices, the
NetCommand
TM
Setup should have been
completed. The NetCommand
TM
Setup will detail
what type and brand of devices are connected and
how these devices are connected to the TV and
A/V Receiver. In addition, you need to connect IR
Emitters to the TV connection labeled IR Emitter
Home Theater Control. IR Emitter ends should be
properly placed in front of each NetCommand
TM
IR
device. You will need to make this connection in
order to control NetCommand
TM
IR devices. The
remote control needs to be programmed to operate
NetCommand
TM
functions. See the TV Owner's
Guide for instructions on connecting IR compatible
devices, using the NetCommand
TM
Setup and
programming the remote control.
Non-NetCommand
TM
IR Devices
When you are using a non-NetCommand
TM
compatible device, select the device on the Device
Selection menu and press ENTer. Then move the
slide switch at the top of your remote control to the
appropriate layer and point the remote control at
the device to control it, or you will need to use the
remote control that came with that device. You can
also use the IR Emitter-Repeater outputs from the
back of the TV.