A/V Receiver (Sound System) - Mitsubishi WD-57833 Owner's Manual

3. TV Connections 23
A/V Receiver
Most setups require either a digital audio cable or
analog stereo audio cables.
The TV makes all audio available in digital and analog
formats:
[] Analog audio coming into the TV is available as
output in digital stereo format on the DiGiTAL
AUDIO OUT jack.
[] Digital incoming audio is available as analog
output on the AVR AUDIO OUTPUT/AUDIO L
(MONO} and AUDIO R jacks,
Usually, only one of the following connections is
required:
• To connect an analog A/V receiver
Connect left (white) and right (red) audio cables
from AVR AUDIO OUTPUT/AUDIO L (MONO} and
AUDIO R on the TV back panel to the TV AUDIO
INPUT on the A/V receiver,
• To connect a digital A/V receiver with Dolby
Digital surround sound and PClVl audio support:
Connect one end of the digital audio cable
to DiGiTAL AUDIO OUT on the back of the TV.
Connect the other end to the COAXIAL DiGiTAL
INPUT on the back of the A/V receiver,
AJV Receiver Panel
!
Stereo Analog Cables
Use to connect an analog
A/V receiver.
Note:
[]
On rare occasions, an HDMI signal may be
copy-restricted and cannot be output from
the TV as a digital signal. To hear these copy-
protected signals through the A/V receiver, use
connections for analog A/V receivers.
Check the A/V receiver's Owner's Guide for
information concerning use of the digital input
and switching between digital sound and
analog stereo sound from the TV.
Required: One coaxial cable.
Note: This connection is not recommended. The
other connections described in this chapter
provide better quality audio and video to the TV
and allow NetCommand to work with the cable
box.
1. Connect the incoming cable to IN on cable box.
2. Connect one coaxial cable from OUT on the cable
box to ANT l/MAIN on the TV back panel.
To ANT l/MAIN 2
TV Back Panel
!
m_
®
Cable Box
Figure 12. Connecting an older cable box
Figure 11. Connecting the TV to an A/Vreceiver