Control Panel Lights - KitchenAid KUDS25SH Use & Care Manual

Sani Rinse option
Select this option to raise the water temperature in the final
rinse to approximately 155 ° F (68 ° C) for 10 minutes. This
high-temperature rinse sanitizes your dishes and
glassware in accordance with the NSF International
requirements (#95/480/05/2480).
%
NOTE: The Anti-Bacteria cycle automatically uses this
option. Sani Rinse is an option with all other cycles, except
Rinse Only and Light/China.
Delay Hours
Select this option to run your dishwasher at a later time or
during off-peak hours.
To delay the start
1. Close the door.
2. Select a wash cycle and option(s).
3. Press DELAY HOURS 1 time for a 2-hour delay, 2 times
for a 4-hour delay, or 3 times for a 6-hour delay start.
%
The number glows above Delay Hours. The dishwasher
starts the cycle in the selected number of hours.
4. Press START.
NOTE: To cancel the delay, press DELAY HOURS until no
number is lit.
IMPORTANT:
Operate your dishwasher only when you are at home.
If your home is equipped with a water softener, do not
start the dishwasher during the regeneration of the
softener.
Control Paael Lights
Cycle Monitor
Follow the progress of your dishwasher cycles on the
Cycle Monitor, CLEAN glows when a cycle is finished, The
light turns off when you open the door.
s | m
m n
m
)I_F_#I*I_KOJ_H£eT
SANI-RINSE
CLEAN COMPLETED
Water Heating light
WATER HEATING glows, and the cycle progression
pauses, whenever water is heated during a cycle. Wash or
rinse action continues as the water heats.
WATER HEATING
Sensing light
Your dishwasher senses the soil level on the dishes. Soil
level determines the length of some cycles, the amount of
heat added to a wash or rinse, and the cycle needed for
the load. SENSING glows during the soil sensing parts of
the cycle. Wash action continues while sensing occurs.
SENSING
Child Lock light
Use Child Lock to prevent your dishwasher from
accidentally being turned on. Use Child Lock, also, to
prevent accidental cycle or option changes during a cycle.
When CHILD LOCK is lit, all buttons are disabled. You can
turn on Child Lock while the dishwasher is running.
CHILD LOCK
To turn Child Lock on
Press and hold
for 4 seconds. CHILD LOCK glows. If you press any pad
while your dishwasher is locked, the light flashes 3 times.
To turn Child Lock off
Press and hold ENERGY SAVER DRY for 4 seconds. The
light turns off.
NOTE: The dishwasher door can be opened while Child
Lock is on.
15