Electronic Control Settings; Settingclockdisplay- On Or Off; Adjustingoventemperature - Electrolux EW30IS65JSC Use & Care Manual

Electronic Control Settings
USERPREFERENCES
(CONTINUED)
[] [] [] [] [] [] [] [] II [] III [] [] [] [] [] [] [] II [] [] []
SETTING CLOCK DmSPLAY--ON OR OFF
The oven control c an be programmed todisplay thetimeof day or not The oven has been
presetatthefactory t odisplay thetimeofday.
Changingclock display b etweenON and OFF:
I. Press USER PREF _ until y ou gettothe CLO
on
menu page.
÷
2. Press moor hi to toggle between displaying or hiding the clock.
3. Press START _I"_ to accept the changes and go back to user preferences menu
display.
SETTINGTIME OF DAYDISPLAYm 12 OR 24 HOURS
The oven control can be programmed to display time of day in 12 hours or 24 hours mode.
The oven has been preset at the factory to display in 12 hours mode.
Changing between 12 or 24 hour time of day display:
1. Press USER PREF e(_ until you get to the CLO 12hr menu page.
+
2 Press Io or hi to toggle the display of the clock in 12 or 24 hours.
3 Press START @ to accept the changes and go back to user preferences menu
display.
4. Remember to set your clock after changing the time of day display mode.
ADJUSTmNG OVENTEMPERATURE
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is too hot or too cool,
the temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed. Each oven can be
individually adjusted.
To adjust the oven temperature:
1. Press USER PREFERENCES _ until you get to the UPO menu page.
2. To select the oven you want to adjust, press USER PREFERENCES _) again to
toggle between the upper and the lower display.
+
3 Enter the temperature by pressing the hi or Io pads. The temperature can only be
adjusted by _+ 35°F.
4. Press START _I"_ to accept the changes and go back to user preferences menu
display.