Installation Checklist - Kenmore 153.320491 HT Owner's Manual

Installation Instructions (cont'd)
Installation Checklist
• Whether or not the element conversion is made, the model
rating plate must be marked. Using a hard point ink pen,
check the appropriate block within the model rating plate,
which is located adjacent to the lower access panel.
• Is the fuse or circuit breaker size correct as shown in the chart
in the "Product Specifications" section?
• Are the wires from the circuit breaker or fuse service to the
water heater's junction box on the correct wire size (gauge) as
shown m the chart in the "Product Spec'fications" section?
Is the new temperature-pressure relief valve properly
installed, and piped to an adequate drain? See "Temperarure-
Pressure Relief Valve" section.
• Is the water heater completely filled with water? See "Filling
the Water Heater" instructions in the "Installation
Instructions" section.
Will a water leak damage anything? See _Facts to Consider
About the Location" section.
• Are the cold and hot water lines connected to the water heater
correctly?. See "Water Piping" instructions in the "Installation
Instructions" section.
• Is there adequate clearance for maintenance around the water
heater?
• Do you need to call your electric company to check your
wiring?
HOT
/[]
COLD
TEMPERATURE-
JPRESSURE
RELIEF VALVE
F---DISCHARGE PIPE
(Do no_ cap or
plug)
6 "AIR GAP
FLOOR DRAIN
MODEL RATING PLATE
15