Vcr Functions - Hitachi 46UX24B Operating Manual

USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
erating the pre-Coded function for your VCR
s Genius Remote is designed to operate different types of VCRs. You must first program the Genius Remote to match
remote system in your VCR. (Refer to Table 1 on page 36 or Table 3 on page 37.)
Set the MULTI-PAGE select switchto "VCR."
Set the USE/LEARN mode selectswitchon the rear side of the Genius Remote to "USE." (For CLU-850GR only)
Turn ON your VCR.
Aim the Genius Remote control at the front of your VCR.
While holding down the SELECT button, press the button that matches your VCR as shown on page 36 or page
37. Continue to hold down both buttons. The channels of the VCR will begin changing when the correct button is
pressed. When this occurs, the Genius Remote Control is programmed for your VCR. If the VCR channels do not
change after 5 seconds, try a different Genius Remote button.
Release both buttonswhen the VCR startsto changechannels.The Genius Remotewill now controlyourVCR.
NOTES:
1. If your VCR cannot be operated after performing
the above procedures, this means that your
VCR's codes have not been precoded into the
GENIUS REMOTE. Please store your VCR
codes in memory by using the USER mode.
(Refer to page 38.)
2. The GENIUS REMOTE CONTROL will remem-
ber the codes you have programmed in until the
batteries are removed from the GENIUS RE-
MOTE CONTROL. After replacing the batteries
repeat the entire programming procedure stated
above.
3. If you have a play back only VCR (no CH UP/
DOWN function), please follow operating step 5
described above and then check a VCR function
until youfindthe button that will allow the precoded
VCR buttons to operate your VCR.
PRECODED VCR BUTTONS
These buttons always transmit the chosen precoded
VCR codes.
SELECT BUTTON
This is for setting up the Genius Remote to transmit
the VCR's remote codes.
) EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.
r-'_ I
I
READY LEARN
HITACHI
GENIUS REMOTE
CLU-850GR
34