Assembly Instructions; Splash Deflector Assembly; Shoulder Harness - Craftsman BRUSHWACKER 636.795454 Owner's Manual

ASSEMBLY INSTRUCTIONS
1. After checking parts, fasten fuel tank and fit drive shaft
to engine with four screws. Figure 1.
5. SPLASH DEFLECTOR ASSEMBLY
Attach the splash deflector unit to the Drive Shaft Hous-
ing using the clamp and screws provided. See figure 4.
GROUND WIRE OF TOGGLE SWITCH
.
3.
4=
/
STAND
Figure 1
Attach stand to engine with two bolts. Figure 1.
Clamp the handle bar to the drive shaft.
Connect the toggle switch cord with the cord coming
from the ignition coil. Figure 2.
Figure 2
Wind the spiral tube round both the throttle wire and
the toggle switch cord as in the figure. Attach waist pad.
Figure 3.
WAIST PAD
SPIRAL TUBE
Figure 3
6.
Figure 4
You are now ready to mount the blade and Arbor
Lock on the end of the drive shaft. CAUTION: The
teeth on the blade are very sharp. Wear gloves and be
careful!
The arbor shaft and nut have left hand threads. Pay par-
ticular attention to blade rotation when installing the
blade. Blade has counter-clockwise rotation when viewed
from the engine end of the machine. When installing the
blade, fasten the shaft with lock handle. Figure 5.
L O CKXANO
@
Figure 5
7.
SHOULDER HARNESS
The SHOULDER HARNESS clips in one of the holes of
the bracket as shown. Adjust so that the blade is parallel
to the ground and you are comfortable. Figure 6.
WARNING! WARNING! WARNING!
The shoulder harness must be worn, the safety handle installed
properly and both hands kept on the handles at all times while
running this unit. Positive control is mandatory for safe
operation. DO NOT EDGE WITH THE METAL BLADE! Keep
blades sharp at all times. Splash deflector must be in place
when using brush blades. For blade replacement, use only
blades built for this unit. DO NOT SUBSTITUTE. Always
shut unit off before disconnecting shoulder harness to examine
blade. BEFORE EACH USE, examine the nuts which hold
blade on to determine if they are tight.