Fence Assembly - Craftsman 152.217050 Instruction Manual

FENCE ASSEMBLY
DO NOT assemble the Jointer/Haner until you are sure
the power switch is in the "OFF" position and the power
cord is disconnected from the power source,
Fig. 10-1
K
J
G
H
B
\
2,
3,
E C G
F
Loosen set screw (A) on fence bevel assembly (B)
and remove the cam lock shaft (C), Remove the bolt
damp (D), M12 fiat washer (E) and M12 Nylock hex
nut (F) from cam lock shaft (C), See Figure 10-1,
Assemble the handles (G) into the fence (H) and
cam lock shaft,
Remove four M8 x 14mm hex socket head screws
(I) and fiat washers (J) from fence, Note: This
hardware was attaching the fence brackets (K) to
the fence,IMPORTANT: Make sure not to change
the orientation of the fence brackets,
Fig. 10-2
K
5,
Once both fence brackets have been placed onto
the front support bracket pins, hold the fence bevel
assembly upright as shown in Figure 10-3,
Assemble the fence brackets to the fence with the
four M8 x 14mm hex socket head screws (I) and
fiat washers (J) removed in STEP 3, Do not com-
pletely tighten hardware, Note: Make sure the
fence brackets stay engaged with the front support
bracket pins,
Fig. 10-4
N
N
4,
Hace both fence brackets (K) onto the four pins (L)
in the front support brackets (M), as shown in
Figure 10-2, Note: Loosen bevel lock handle (N)
and pull back the 90-degree stop knob (0) to allow
movement of the front support brackets for align-
ment of the pins to the fence bracket,
6,
15
Allow the fence bevel assembly (B) to rotate forward
as shown in Figure 10-4, Securely tighten all hard-
ware and bevel lock handle (N),