Craftsman 917.249393 Owner's Manual page 12

SUPPORT POST
ASSEMBLY
5. Assemble the support post assembly to the rear
mounting bracket (Fig. 10) using support bracket
pin and retainer spring, Retainer spring shown full
size below. Support post, latch pin and retainer
spring furnished with bagger.
/
RETAINER
SPRING
REAR
MOUNTING
BRACKET
FIGURE 10
J
SUPPORT
BRACKET
PIN
6, Install end plug (Fig° 1t) on elbow support tube,, End
plug furnished with bagger_
7_ Mount the elbow retainer and the elbow shield to
the elbow support tube (Fig. 1 1) using: two form-
ed washers and two 5/16 locknuts (shown full size
below). NOTE: Do not tighten, Elbow retainer,
elbow shield and hardware furnished with bagger_
FORMED
SUPPORT POST
ASSEMBLY
ELBOW
RETAINER
8. Locate the small hole in one end of the elbow, Slide
this end of the elbow through elbow retainer (Fig_
12 - Inset), Secure elbow to elbow retainer using:
one clip, one screw, two washers, and one acorn
nut_ NOTE: Mount clip in hole located 2 - I/2"" from
edge of elbow. Hardware shown fult size below.
Head of screw and one flat washer mount to the
inside of elbow,, Position clip with closed end
facing tube opening as shown in Fig,, t2 - Inset,
Tighten securely. NOTE: Tighten hardware
assembled in step 7,, Elbow and hardware furnish-
ed with grass catcher,
9 ,. Flip seat forward,
FIGURE 11
12