Craftsman 917.249393 Owner's Manual page 10

\
R H FOOTREST
DISCHARGE
JARD
9o Using a 1/2" wrench remove hardware "D" (Fig.
5 - Inset) securing discharge guard to mower hous-
ing, Hardware may be discarded°
10o Using a 1/2" wrench remove hardware "A", "'B"
and "'C" (Fig. 6) securing R.H. runner to mower
housing, Hardware may be discarded.
1 1_ Place R,H. baffle (Fig° 4) on lip of mower housing,
Secure R,Ho runner to R,H, baffle and mower hous-
ing using: one 5/16 carriage bolt and one 5/16
locknut (shown full size below). NOTE: Do not
tighten, RH. baffle and hardware furnished with
grass catcher_
FIGURE 5
MOWER
HOUSING
1 2, Secure R,H, baffle to mower housing using: one
clamp, one 1/4 hex bolt and one 1/4 locknut {shown
full size below) Clamp and hardware furnished with
grass catcher,
a_
11ttll!11 illll] Q
Place clamp (Fig° 7) over hole in RHo baffle (Fig.
7) Bolt head to underside of mower housing,.
Tighten securety_
13_ Assemble front latch bracket to top of R.H, runner
(Fig. 8) using: two 5/16 carriage bolts and two 5/16
locknuts (shown full size below),. Bolt heads to
underside of mower housing. Tighten securely.
Front latch bracket and hardware furnished with
grass catcher. NOTE: Tighten hardware assembl-
ed in step 1 1_
FIGURE 6
FIGURE 7 10