Craftsman Mow-N-Vac 486.24505 Owner's Manual page 8

• Autimble the front p_mel over the end of the cart
using six 1/4" x 1/2' hex bolts and 1/4" hex nuts
(SEMS) as shown in figure 4. Leave two holes open
in the bottom of the panel as shown in figure 4. With
the cart body halves pulled together, tighten the four
bolts In the bottom of the front panel, then tighten the
boltln each side.
At this time tighten the three bolts on the bottom of
the cart which were assembled in figure 1.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" x 1/2"
HEX BOLTS
114" HEX
NUT (SEMS)
/
I
/
1/4" HEX
NUT (SEMS)
FIGURE 4
• Assefnble the latch stand braCKet to tne cart uslng
four I/4' x I/2" hex bolts and I/4" hex nuts (SEMS).
TIGHTEN. See figure 6.
LATCH STANDBRACKET
1/4" x 1/2'
HEX BOLT
1/4" HEX NUT (SEMS)
FIGURE6
To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down on the top flanges, so that the wheel support is
facing up. Refer to figure 10 on page 9.
Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4" slotted head screws and
5/16" hex nuts (SEMS) as shown in figure 5. Heads of
screws go to the inside of cart. Tighten.
WHEEL
SUPPORT
\
SLO'I-rED SCREW
5/16" x 3/4"
l
NUT(SEMS
FIGUI_E 5
ASSEMBLY OF PARTS IN MOW-N-VAC CARTON
• Assemble the front tongue over the top of the rear
•tongue using three 3/8" x 3-1/4" hex bolts, 3/8" lock
washers and 3/8" hex lock nuts. See figure 7.
_j.13/8" X 3-1/4" HEX BOLT
TONGUE
(REAR) _ TONGUE
3/8" LOCK _
WASHER 3/8" HEX
LOCK NUT
FIGURE 7
8