Craftsman 247.24020 Operator's Manual page 10

Assembling Remaining Bagger Components
Nowthat themountingbracketsare assembledand are inplaceon
thetractor,followthese stepsto assemblethe remainingbagger
components.
1. Snapthe upper chutesupportin placeby firstclippingthe side
portionontothe bin support rail.Alignthe edge of the snap
featurewith the red line (1),as shownin the inset of Fig.9.
2. Snapthe front portionof the upperchute supportto the bin
supportrail as seen in2 of Fig.9.
Make surescreensitsunderthe cover'slip
.J
Figure11
5. Installthe grasscatchercoverontothe bin supportassembly,as
seen in Fig. 12.The grasscatchercovergoesinside of the two
mountingtabs on the bin supportassembly.
,
Figure9
Installthegrass catchercover screenintothe baggercoverby
first inserting t he end closestto the side withthe cutoutintothe
mountinghole,as in Fig. 10. Makesureto feedthe screenunder
the lip,as in Fig. 11.
,
Cover mounts ir
between these
two tabs
J
Figure12
Slide the hinge pin intothe hole locatedon the mountingtab, as
in Fig. 13. Usethe cut-outwindow(See inset in Fig. 13)to line up
the hinge pin on the otherside and pushpin all the wayin until it
reachesthe end-stop.Atthis pointthe pin clips intoplaceand is
securedby a tab inthe baggercover.See Fig. 14.
,
Figure10
Clip inthe otherside byflexingthe screenand pushingitdown
intothe providedcutouthole.See Fig. 11.
10