Getting Started; Ovenventlocation; Installing Ovenracksupports; Removing And Replacing Ovenracks - Electrolux E30EW8CESS1 Use & Care Manual

Getting Started
BEFORE SETTING OVENCONTROLS
Oven Vent Location
The oven is vented under
upper control panel for
the upperoven and
between the doors for the
lower oven. When the oven
is on, warm air is released
through the vent. This
venting is necessary for
proper air circulation in the
oven and good baking
results.
InstallingOven Rack Supports
AL WAYS INSTALL OVEN RACK
SUPPORT BEFORE TURNING ON
THE OVEN (WHEN THE OVEN IS
COOL).
To install oven rack support, insert
the support tabs in the holes located
on the oven inside side as shown
below. To remove the oven rack
support for a self-clean cycle, pull up
the support to disengage the tabs
from the oven. If the rack supports are
not removed, the self-clean cycle
won't start. Always remove the left
side support first.
Removingand ReplacingOven
Racks AL WAYS ARRANGE OVEN
RACKS WHEN THE OVEN IS COOL
(PRIOR TO OPERA TING THE OVEN).
Always use oven mitts when using the
ovenl
To remove an oven rack, pull the rack
forward. Lift up the rack off the oven rack
slider. To install an oven rack, locate
the two pinholes in the small plates at
the front corners of the rack. Place the
rack on the side sliders and drop the pin
holes over the pins on the sliders.
instaUed on sliders
To remove from
sliders
To place on sliders
Pull oven rack forward and lift it
up off the oven rack slider,