Replacing Cutter Blades; Maintenance - Craftsman 113.20680 Owner's Manual

BROCK OF WOOD
,,/
t: Remove belt guard. :......... _
2. POsitiOn fer_ce to right.., approximately I/4 in.
beyond cutter blades . , . lock it in=. place.
3. Lower infeed table atl the way down.
4_ Place block of wood 6-3/4 in. long between cutter-
guard and fence.
5. Hold cutterhead pulley firmly with one hand and
loosen lockscrews in each wedge using a 5/32 in,
setscrew wrench.
5/32 iN.
SETSCREW
WRENCH
HOLD PULLEY
FIRMLY
TURN COUNTER
CLOCKWISE
BLADE WEDGE
LI FTER LOCKSCREW
SCREW
FENCE NOT SHOWN
FOR PICTURE CLARITY
6. While holding cutterhead pulley firmly with one hand,
gently pry up each wedge using a screwdriver.., re-
move wedgesand blades.
I 1
SMALL SCREWDRIVER
r