Adjusting The Number Of Messages To Be Output Per Monitoring Interval - Hitachi XP P9500 User Manual

6 Press the Enter key.
.
The new setting is applied and the Hitachi Network Objectplaza Trace
Library setup menu appears again.
Adjusting the Number of Messages to Be Output Per Monitoring
Interval
To adjust the number of messages to be output to fit a particular
monitoring interval:
1 In the Hitachi Network Objectplaza Trace Library setup menu, type 6, and
.
then press the Enter key.
A screen to set the monitoring interval for the number of messages
output to the integrated trace file appears. The current value is displayed
in Current Span (sec).
2 Enter a desired interval in New Span(sec).
.
You can specify a value from 0 to 3600 (seconds). The default and
recommended value is 0.
If you do not want to change the monitoring interval, leave New
Span(sec) blank, type !, and then press the Enter key to return to the
Hitachi Network Objectplaza Trace Library setup menu.
Note that when you specify a monitoring interval of 0, even if you specify
the maximum number of messages in 7: Max messages per span, the
amount of integrated trace information to be output will not be adjusted.
3 Press the Enter key.
.
The new setting is applied and the Hitachi Network Objectplaza Trace
Library setup menu appears again.
4 In the Hitachi Network Objectplaza Trace Library setup menu, type 7, and
.
then press the Enter key.
A screen to set the maximum number of messages output to the
integrated trace file based on the monitoring interval specified in 6:
Lookout span appears. The current value is displayed in Current
Max(sec).
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-133