Convenient Operation Of The Unit - Sharp MD-MT15H Operation Manual

CONVENIENT OPERATION OF THE UNIT

Checking the remaining amount
of battery level
The remaining amount of battery level is
shown by the battery indicator (
ing operation.
Battery indicator
< How to read the battery indicator >
When the battery
level is high
Since the battery level is very low, you
cannot start recording or editing.
When the battery is completely discharged,
the battery indicator will flash. Recharge the
battery or replace the alkaline batteries with
a new one.
When the battery has run completely out,
"BATT EMPTY" will appear. Then, the
power will be disconnected automatically.
Notes:
When using the unit with alkaline batteries
or a rechargeable battery, the battery indi-
cator will not correctly display the remain-
ing capacity for approximately 10 seconds
after the power has been turned on.
When an AC adaptor or a car adaptor is
used, the battery indicator will not be shown.
The number of bars shown in the battery
indicator may increase or decrease, de-
pending on the operation being performed.
This is normal.
* MT15H FOR SEEG(E20-E40)
To prevent the unit from being
operated by mistake
To avoid accidental operation of the unit,
use the hold function.
) dur-
Move the HOLD switch to the safety posi-
tion (direction indicated by the arrow).
When the unit is in the hold mode, press-
ing the buttons will have no affect.
When the battery
level is very low
To cancel the hold mode, move the
HOLD switch away from the safety po-
sition (the opposite direction of the ar-
row).
If the hold function is active whilst the power
is turned off, the power cannot be turned
on by mistake and the battery will not be
accidentally drained.
E-31
12 1999.05.07, 9:02