Convenient Operation Of The Unit - Sharp MD-MS722H Operation Manual

CONVENIENT OPERATION OF THE UNIT

Checking the remaining
amount of battery charge
The remaining amount of battery charge is
shown by the battery indicator (
ing operation.
Battery indicator
< How to read the battery indicator >
When the battery is
completely charged
When the battery needs charging, it is
impossible to start recording or editing.
When the battery is completely dis-
charged, the whole battery indicator will
flash. Recharge the battery or replace the
alkaline battery with a new one.
When the battery has run completely out,
"BATT EMPTY" (main unit) and "Lo BATT"
(remote control unit) will appear. Then, the
power will be disconnected automatically.
Notes:
When you are using the unit with a re-
chargeable battery and an alkaline battery
and you want to check the remaining ca-
pacity of the battery, the remaining battery
charge display may not be stable for about
20 seconds after the power is first turned
on.
When the AC adaptor included with this
unit or a separately available car adaptor
is used, the battery indicator will not be
shown.
The number of bars shown in the battery
indicator may increase or decrease, de-
pending on the operation being per-
formed. This is normal.
When the rechargeable battery and the
alkaline battery are used at the same time,
the rechargeable battery is used first, and
then the alkaline battery.
Since the battery indicator shows the re-
maining amount of the particular battery
being used, the number of bars will in-
crease when the unit switches to the alka-
line battery.
To prevent the unit from
being operated by mistake
To avoid operations being started by acci-
) dur- dentally pressing the buttons, use the hold
function.
Move the HOLD switch to the safety posi-
tion (direction indicated by the arrow).
When the unit is in the safety mode,
pressing the buttons will have no affect.
Charging is
needed.
To cancel the safety mode, move the
HOLD switch away from the safety po-
sition (the opposite direction of the
arrow).
Can be operated
from either the
remote control unit or
the main unit.
Can only be operated
from the remote
control unit.
Can only be operated
from the main unit.
Cannot be operated
from either the
remote control unit or
the main unit.
If the hold function is active whilst the
power is turned off, the power cannot be
turned on by mistake and the battery will
not be accidentally drained.
35
Remote Main
control unit unit
Cancel Cancel
Cancel Hold
Hold Cancel
Hold Hold
MD-MS722H(SUK)