Advertisement
CUSTOMER RESPONSIBILITIES
Filt i ndates asyou complete Before A fterEvery Every Y early Service
regular service
Use Uset5rain. 5 hrs.
Dates
Check fordamaged/worn
parts
,.,
_,
_,
Check for loose fasteners/parts
_.
_.,
Check chain tension
_I
_.
Check chain sharpness
/-."
_"
Check guide bar
/-."
_"
_'
Clean unit & labels
._,
GENERAL
RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence.
To re-
ceive futt vaiue from the warranty, the
operator
must maintain
unit as instruct-
ed in this manual
Various adjustments
wiit need to be made periodically
to
propedy
maintain your unit.
• Once a year, check guide bar and
chain for wear.
WARNING:
Disconnect
the power
source before performing
maintenance.
LUBRICATION
I Bar
2 Bar Oil
Sprocket
FilI Cap
2 Use Craftsman chain saw bar oil
CHECK
FOR
DAMAGED
OR
WORN
PARTS
Replacement
of damaged/worn
parts
shoutd be referred to your Sears Ser-
vice Center.
NOTE: tt is normal for a smatt amount
of oil to appear under the saw after mo-
tor stops. Do not confuse
this with a
leaking oil tank.
• Trigger Switch - Ensure the trigger
switch functions
properly
by squeez-
ing and holding the trigger switch.
Make sure motor starts and stops.
• Oil Tank - Discontinue
use of chain
or leaks.
• Extension
Cord - Discontinue
use if
chain saw extension
cord shows
signs of damage
or wear.
CHECK FOR LOOSE
FASTENERS
AND
PARTS
• Bar Clamp Nut
• Chain
• Bar Adjusting
Screw
CHECK
CHAIN
TENSION
• Chain tension
is correct when the
chain can be lifted about 1/8" from the
guide bar at a point near the middle of
the bar,
• With your unit unplugged,
check
your chain to make sure it is
properly tensioned,
• When your chain needs tensioning,
use the following
procedure:
NOTE:
It is recommended
that the saw
be turned upside down for chain
tensioning.
• Unplug unit from the power source.
• Loosen bar nuts untit they are only
finger tight.
• Turn the adjusting
screw clockwise
until the drive links on the chain enter
the guide bar groove.
Drive Links
NOTE: To tighten the chain, turn the
adjusting
screw clockwise;
to loosen
the chain, turn the adjusting
screw
saw if oil tank shows signs of damage
counterclockwise.
t2
Advertisement
