Craftsman 113.24140 Owner's Manual page 5

assembly
MOUNTING SAW ON CRAFTSMAN FLOOR BASE
1.
2.
3.
Place saw on base so that front corners of saw are even
with corners of base.
Find four hex. head bolts 3/4 in. long, nuts and washers
furnished with base.
Insert all four bolts through holes in saw and base ...
install washers and nuts ... tighten nuts using 1/2 inch
wrench.
If you mount the saw on any other bench, make sure
that there is an opening in the top of the bench the
same size as the opening in the bottom of the saw so
that the sawdust can drop through. Recommended
working height is 33 to 37 inches from the top of the
saw table to the floor.
INSTALLING ELEVATION AND TILT CRANKS
1. Line up set screw in cranks with FLAT SPOTS on
shafts ... tighten screws using 1/8 inch set screw
wrench furnished with saw.
INSTALLING FENCE GUIDE BAR
1. Find three pan head screws 10-32 x 3/4 inch,
Iockwashers and hex. nuts among the loose parts.
2. Insert screws through BAR ... through table ...
install washers and nuts ... don't tighten.
NOTE: The holes are larger than the screws, therefore
the bar can be adjusted UP or down.
3. Place a square against the fence ... if the fence is not
square with the table, move one end of bar UP or down
until fence is square ... tighten screws.
FENCE GUIDE BAR
3/4 IN. SCREWS
ALIGNING RIP FENCE
The rip fence must be PARALLEL with the Sawblade and
Miter Gage grooves. Push fence head against table ... move
fence until it is along side of groove. It should be parallel to
groove. If it is not;
a. Loosen the two "hex screws".
b. Move end of fence so that it is parallel with the
groove.
c. Tighten the knob.
d. Tighten the screws.
LOOSEN
RIP FENCE
HEAD